46
Chapter 3 Printer Adjustments
Sensor Adjustments
Adjusting the Transparent sensor
1. The transparent sensor is selected.
2. Install only the liner media (label backing paper) with the
label media removed so that it will pass between the platen
roller and the media sensor. (Be careful that media with
black marks does not pass the media sensor.) Then close the
printer cover.
Label
Media gap
Bottom sensor
Upper sensor
Liner media
3. If the PAUSE Key is pressed then released while the MENU
key is continually pressed, the sensor is automatically
adjusted.
Sensor Cal Mode
Executing
Hold Press/Release
MENU
PAUSE
4. When automatic adjustment stops normally, “Succeeded”
is displayed by the LCD. If it stops abnormally (adjustment
is impossible), the POWER LED lights up red and “Failed” is
displayed on the LCD.
Sensor Cal Mode
Succeeded
5. If the STOP key is pressed, the Printer completes sensor
adjustment and the printer restarts.
Installing the Media (p.22)
Sensor Selection Method
(Transparent
Reective) (p.45)
To Next Page
Loading...
