47
Chapter 3 Printer Adjustments
Sensor Adjustments
Adjusting the Reective sensor
1. The reective sensor is selected.
2. With the reective sensor selected, install the label media
so that it is between the platen roller and the media sensor.
Be careful that black mark and media gap do not pass the
media sensor. Then close the printer cover.
Black mark
Label
Liner media
Bottom sensor
3. If the PAUSE Key is pressed then released while the MENU
key is continually pressed, the sensor is automatically
adjusted.
Sensor Cal Mode
Executing
Hold Press/Release
MENU
PAUSE
4. When automatic adjustment stops normally, “Succeeded”
is displayed by the LCD. If it stops abnormally (adjustment
is impossible), the POWER LED lights up red and “Failed” is
displayed on the LCD.
Sensor Cal Mode
Succeeded
5. If the STOP key is pressed, the Printer completes sensor
adjustment and the printer restarts.
Installing the Media (p.22)
Sensor Selection Method
(Transparent
Reective) (p.45)
To Next Page
Loading...
