3-5. Disassembly, Reassembly and Lubrication
3-33 CLP-621 & CLP-631
Tip: To remove the Head SA without disassembling the Head Unit
You can remove the Head SA without disassembling the Head Unit. Though, the normal
disassembly procedure is described in (1) “Head Unit” on page 3-
30.
1. Raise the head block. (The following figure omits the Ribbon Unit.)
2. Disconnect the connector of the Head Cable SA from the Head SA.
3. Remove 1 screw (BH (N), M3x6) and detach the Head SA.
SA, Head Cable
SA, Head
BH (N), M3x6
To Next Page
Loading...
