3-5. Disassembly, Reassembly and Lubrication
3-37 CLP-621 & CLP-631
3-5-22. Gears
1. Remove the Mechanism Unit. Refer to 3-5-13 “Mechanism Unit and Case L”.
2. Remove the PF Unit. Refer to 3-5-17 “Head Block and PF Unit”.
3. Remove the Motor SA. Refer to 3-5-20 “Motor SA”.
Tip: You can remove the gears without removing the PF Unit and the Motor SA.
4. Pull out the PF2 Gear by releasing its lock, and then pull out the PF1 Gear and the PF Idle
Gear.
FLOIL G-311S
Gear, PF2
Gear, PF1
Gear, PF Idle
Notes on reassembling:
• Apply Floil G-311S to each gear shaft (3 shafts) and to each gear surfaces.
• The PF Idle Gear has no directionality, but other gears have.
To Next Page
Loading...
