3-6. Adjustments
CLP-621 & CLP-631 3-42 CLP-621 & CLP-631 3-42
5. Peel off the label from liner (base) and set the liner part to
the printer. Be sure that the normal adjustments for
printing are correctly made.
• Media sensor menu: “See Through”
• Sensor positioning:
5. Peel off the label from liner (base) and set the liner part to
the printer. Be sure that the normal adjustments for
printing are correctly made.
• Media sensor menu: “See Through”
• Sensor positioning:
The upper sensor marker should meet the bottom sensor
marker on the right side.
The upper sensor marker should meet the bottom sensor
marker on the right side.
Tip: Tip:
Guide, Paper Set
Aligned
When you move the upper and bottom
sensors to the right end (center of the printing
mechanism), they match with each other for
“See Through” position.
When you move the upper and bottom
sensors to the right end (center of the printing
mechanism), they match with each other for
“See Through” position.
Also, when you push the Paper Set Guide
toward them in any poison, they match with
each other as shown:
Also, when you push the Paper Set Guide
toward them in any poison, they match with
each other as shown:
6. Press the [FEED] key to enter the transparent sensor adjustment mode. 6. Press the [FEED] key to enter the transparent sensor adjustment mode.
7. Press the [PAUSE] key to move the cursor to “Exec.”.
8. Press the [FEED] key to perform adjustment.
Liner is automatically fed little by little and adjustment is performed.
During adjustment, the following screen appears.
To Next Page
Loading...
