3-6. Adjustments
CLP-621 & CLP-631 3-44
12. Set tag with black marks, but avoid placing the black
mark part on the reflective sensor.
Black mark
If you use continuous tag, set it to the printer.
Be sure that the normal adjustments for printing are
correctly made.
• Media sensor menu: “Reflect”/”None” (for continuous
paper)
• Sensor positioning:
The bottom sensor should meet the black mark position.
(However, avoid black mark.)
13. Press the [PAUSE] key to move the cursor to “Exec.”.
14. Press the [FEED] key to perform adjustment.
Tag is automatically fed little by little and adjustment is performed.
During adjustment, “Now!! Executing” appears.
When adjustment is successful, “Finished DAC XXX” is displayed.
*The value “168” is one of samples.
15. Press any key on the control panel to store the adjusted value.
Then, the screen returns to the one in step 10 and “Ini Refl Sensor” is displayed.
16. Turn OFF the power to terminate the adjustment.
To Next Page
Loading...
