3.3 Ethernet (LAN) Interface
The following describes an overview of the Ethernet (LAN) interface.
For details on this function, refer to a separate manual.
Note that the Ethernet (LAN) interface is not available in the USB model.
Panel button operation
The function of the panel button is as follows.
l Printing network setup information
Press the panel button.
l Returning to factory settings
Hold down the panel button. A buzzer* will sound and then hold down the panel but-
ton again within 3 seconds. It returns network settings to its factory settings.
* Depending on settings, the buzzer may not sound.
Notes
n The board will automatically restart after this operation is complete.
n If settings are configured to obtain an IP address from a DHCP server automatically, the new
IP address may be different from the previous one.
LED Functions
The tables below explain how to interpret LED indications.
– 32 –
To Next Page
Loading...
