— 6 —
THESE LABELS INDICATE THE
RISK OF ANY INJURY DUE TO
"HIGH TEMPERATURE" OF THE
PRINT HEAD AND "SAW-
TOOTHED EDGE" OF THE
MANUAL CUTTER.
Caution label is attached on the position shown in the following figure. Carefully
read the precautions in handling before using the printer.
To prevent possible malfunction or failure observe the following.
■ Avoid operating the printer without paper properly loaded.
■ Avoid the use of paper not complying with specifications.
• May result in poor print quality.
■ Avoid using torn pieces of paper or spliced with plastic adhesive
tapes.
■ Avoid forcibly pulling already loaded paper by hand.
■ Avoid wedging the paper into the printer.
• May jam paper. To release, refer to “Removing Jammed Paper” in
this manual.
■ Avoid using a sharp pointed device to operate panel keys.
■ Be sure to firmly insert the cable plug into its mating socket.
•A cross connection may damage the printer’s internal electronics or
the host system’s hardware.
■ Only use the printer with devices that have designated solenoid
specifications for the cash drawer interface connector.
• Neglecting this caution may result in malfunction or failure.
CAUTION
■ Do not transport this printer with the paper roll inside.
• Printer failure or breakage may occur.
To prevent injury and printer failures from worsening, observe the following:
■ Do not touch the printing surface of the thermal head.
■ Do not touch any of the moving parts (e.g., paper cutter, gears, active
electrical parts) while the printer is working.
■ In case of trouble do not attempt to repair the printer. Ask Citizen
Systems service for repair.
■ Be careful that the printer cover does not entrap your hands or fingers.
■ Be careful with sharp edges on the printer. Do not allow them to
injure you or damage property.
• May result in electric shock, burn, or injury.
If the printer emits smoke, an odd smell, or unusual noise while printing, immediately
abort the current print session and unplug the printer from the supply outlet.
To Next Page
Loading...
