[Chronograph Measurement]
1. Turn the crown to set the mode hand to the
chronograph [CHR] mode.
2. Press button (A) to start and stop the
chronograph. A confirmation tone is heard
whenever button (A) is pressed.
3.
Continuously pressing button (A) when the
chronograph is stopped causes the
chronograph second hand and chronograph
minute hand to be reset to the 0 position
12. SETTING LOCAL TIME
The local time function allows the time in a different time zone to be set
separately from the current time. Local time is set by performing a time
difference correction in 1-hour units based on the current time (time of the time
mode/TME). The minute and second hands move in coordination with the current
time.
[Time Difference Correction Procedure]
1. Turn the crown to set the mode hand to
the local time [L-TM] mode.
2. Pull out the crown to Position 2 (local
time setting position).
3. Click the crown to the right or left to
correct the time difference.
• When the crown is clicked to the
right, the hour hand moves by I hour
in the clockwise direction.
• When the crown is clicked to the left,
the hour hand moves by 1 hour in the
counter-clockwise direction.
Note:
The hour hand is not advanced rapidly even if the crown is continuously
clicked two or more times. Perform correction accurately I hour at a time.
Furthermore, the range of time difference correction is ± 23 hours based on the
current time.
4. Always make sure to return the crown to the normal position after correcting
the time difference.
Note:
If the hour hand passes 12:00 AM (midnight) during correction, the date
is advanced by I day following completion of hand movement. If the time
difference is corrected in the counter-clockwise direction and the hour hand
passes back over 12:00 AM, although the date is corrected following completion
of hand movement, since the date is corrected by 30 days in the clockwise
direction, it takes about 2-3 minutes for the date to be corrected. Pay
attention to AM and PM when correcting time difference.
Note:
When returning the time difference to original setting, return the hour
hand in the direction opposite that when the time difference was corrected.
Return to Table of Contents
Return to Table of Contents
To Next Page
Loading...
