(1) Clicking the crown once to the right causes the hour and minute hands to
move clockwise.
(2) Clicking the crown once to the left causes the hour and minute hands to
move counter-clockwise.
• Turning the crown rapidly (clocking continuously two or more times) causes
the hands to advance rapidly. When stopping the hands, click the crown once
to the right or left. When the hands are not stopped manually, they stop
automatically after being corrected by 12 hours.
10. SETTING THE TIME AND DATE
[Setting the Time]
1. Turn the crown and align the mode hand at the
time/calendar [TME] mode.
2. When the crown is pulled out to Position 2 (time
setting position), the second hand rapidly advances
to the 0 seconds position and stops
Note: When the second hand does not stop Second
hand does not stop at the 0 seconds position, reset
the base position in the "O-Position Correction
Mode"
Note: If the crown is pulled out to Position 2
when the date is changing, the date wheel and
function hand stop at the time, and are then
advanced by the remaining amount after the second
hand is rapidly advanced to the 0 seconds position.
O-Position Correction of 24-Hour Hand, Hour Hand, Minute Hand and Second Hand:
1. Pull the crown out to Position 2 in the chronograph [CHR] mode to correct each
hand.
2. Pressing button (A) causes the second hand to be corrected by one second at a
time each time it is pressed. Continuously pressing button (A) causes the
second hand to advance rapidly.
3. Clicking the crown allows correction of the 24-hour hand, hour hand and minute
hand.
Return to Table of Contents
Return to Table of Contents
To Next Page
Loading...
