Citizen Eco-Drive Proximity - Disconnecting the Iphone [DCT]; Maximum Continuous Connection Time

10
You can close the Bluetooth connection between the watch and iPhone.
1
Change the mode of the watch to [
DCT
].
The connection is closed and the function hand on the upper right sub dial
points the “
OFF
” area.
Maximum continuous connection time
To conserve energy, the connection is automatically terminated when approximately six
hours has elapsed since the connection started.
• You may however connect again and start a new six-hour period. (See page
11
)
Set the mode to [
DCT
] to use this watch as a standard one in places such as an airplane,
where electronic devices are limited to use.
Disconnecting the iPhone [DCT]
Function hand
on the upper
right sub dial