iDP3550/3551 Service Manual
7 CITIZEN
6. Removing the Auto Cutter AC-134
(1) Remove the top cabinet.
(2) Cut the cable tie to set the cable of the auto cutter AC-134, that is fastened to the printer mecha-
nism, free.
(3) Disconnect the one connector from the control board.
(4) Loosen (not remove) the one screw (M2.6×6) and disengage both cutter BK from the cutter BK
mounting holes on the printermechanism chassis to remove the auto cutter.
To Next Page
Loading...
