iDP3550/3551 User’s Manual
103
CITIZEN
ESC "c" "4" n
[Function] Selecting the paper near end sensor valid for print stop
[Code] <1B>H<63>H<34>H n
[Range] 0 ≤ n ≤ 255
[Outline] This command selects the no-paper detector state in which printing should be stopped.
Valu e
Bit Function
0 1
0 Paper near end Disabled Enabled
1 Undefined
− −
2 Undefined
−
−
3 Undefined
−
−
4 Undefined
−
−
5 Undefined
−
−
6 Undefined
−
−
7 Undefined
−
−
[Default] n = 1
ESC "c" "5" n
[Function] Selecting the panel switch enable/disable
[Code] <1B>H <63>H <35>H n
[Range] 0 ≤ n ≤ 255
[Outline] This command enables/disables the panel switches. n is valid only for the least significant
bit.
Setting n = 1 disables the panel switches.
Setting n = 0 enables the panel switches.
[Caution] If the panel switches are disabled with this command, the LF switch will be disabled.
Therefore, the paper cannot be fed by the LF switch.
[Default] n = 0
To Next Page
Loading...
