Page 28
129) (continued from previous page) Aer installing
the App, I am able to successfully pair my iPhone 5 or
higher, but aer a loss of Bluetooth® communication,
I cannot reconnect. I have SCAN turned “ON” in
the App, the iPhone® 5 or higher screen dims and
turns bright, but “Scan” never changes to “Proximity
Connect” in the Proximity App and a Bluetooth®
reconnection never occurs. How do I reconnect?
continued from previous page:
o
A pairing notication will appear on your iPhone®
o
Tap on Pair
o
e watch and iPhone will pair
o
You should now see ‘Proximity Connect’ on your
Proximity App and the hand at the 2:00 sub dial on
your watch should now be indicating between 1:00
and 6:00.
o
If you get an immediate Link Loss notication on
your watch aer pairing:
o
Press and hold the upper right button for
2-3 seconds to clear the notication on
your Proximity Watch
o
Make sure Scan is ‘ON’ in the Proximity
App.
o
Press and release the upper right button to
initiate a connection.
o
You should now see ‘Proximity Connect’
on your Proximity App and the hand at
the 2:00 sub dial on your watch should now
be indicating between 1:00 and 6:00.
To Finalize setting:
o
On your Proximity watch, Pull the crown
out one ‘click”
o
Rotate the crown to change modes to the
TME (Time) mode
o
Push the crown in one ‘click’
is completes this procedure
Proximity FAQ
To Next Page
Loading...
Need help?
General
