earbox
- automatic mode: gear selector in
position A .
- manual mode: gear selector in
position M .
For safety:
It is only possible to come out
of position N if the brake pedal is
pressed.
The change from position A (driving in
automatic mode) to position M (driving
in manual mode) or vice versa can be
made at any time. The warning lamp A
goes off in the instrument panel.
Moving off
- To start the engine, the gear
selector must be in position N .
- Press fi rmly on the brake pedal.
- Operate the starter.
- When the engine is running, place
the gear selector on R , A or M as
desired.
- Release the brake pedal and
accelerate.
If the gear selector is not in position N ,
and/or if the brake pedal is not
pressed, the engine will not start.
Repeat the above procedure.
Mode selection
Reverse gear
Engaging reverse gear
Move the gear selector to R .
Only attempt to select reverse gear
when the vehicle is stationary.
Neutral
Changing to neutral
Move the gear selector to N . If the
vehicle is moving, do not select this
position even momentarily.
To Next Page
Loading...
