9
Driving
123
Display in the instrument panel
N. Neutral
R. Reverse
1 2 3 4 5 / 6. Gears in manual mode.
AUTO. This comes on when automated mode
is selected. It goes off when changing
to manual mode.
F Select position N.
F Press the brake pedal fully.
F Start the engine.
N appears in the instrument panel.
F Select automated mode (position A),
manual mode (position M) or reverse
(position R).
AUTO and 1, 1 or R appear in the
instrument panel.
F Release the parking brake.
F Progressively take your foot off the brake
pedal.
F Accelerate away.
Depending on the type of electronic
gearbox, the vehicle may move off on
its own.
For more information, refer to the
"Creep function" section.
Do not press the brake and clutch
pedals simultaneously. This can cause
rapid clutch wear.
If the engine does not start:
- If N is flashing in the instrument
panel, move the gear selector to
position A, then to position N.
Moving off
- If this warning lamp comes on,
accompanied by an audible
signal and the display of a
message, press firmly on the
brake pedal.
To Next Page
Loading...
