Checks
144
Bonnet
Opening
F Push the exterior safety catch B to the left
and raise the bonnet.
F Unclip the bonnet stay C from its housing,
holding it by its foam protection.
F Fix the stay in the notch to hold the bonnet
open.
F Take the stay out of the support notch.
F Clip the stay in its housing.
F Lower the bonnet and release it at the end
of its travel.
F Pull on the bonnet to check that it is fully
latched.
F Open the front left door.
F Pull the interior release lever A, located at
the bottom of the door aperture.
The location of the interior release lever
prevents opening of the bonnet while
the front left door is closed.
When the engine is hot, handle the
exterior safety catch and the stay with
care.
Before doing anything under the
bonnet, switch off the Stop & Start
system to avoid any risk of injury
resulting from an automatic change to
START mode.
Closing
To avoid damaging the electric units,
the use of a high pressure jet wash
under the bonnet is strictly prohibited.
To Next Page
Loading...
