7
CHILD SAFETY
134
"ISOFIX" MOUNTINGS
There are three rings for each seat:
- two rings A , located between the
vehicle seat back and cushion, indi-
cated by a marking,
- a ring B , behind the seat and identi-
fi ed by a marking, referred to as the
TOP TETHER for fi xing the upper
strap.
This ISOFIX mounting system provides
fast, reliable and safe fi tting of the child
seat in your vehicle.
The ISOFIX child seats are fi tted with
two latches which are secured on the
two rings A .
Some seats also have an upper strap ,
which is attached to ring B .
The incorrect installation of a
child seat in a vehicle compro-
mises the child's protection in
the event of an accident.
Follow strictly the fi tting instruc-
tions provided by with the child
seat.
For information on the possibilities for
installing ISOFIX child seats in your ve-
hicle, refer to the summary table.
When fi tting an ISOFIX child
seat to the left hand rear seat,
before fi tting the seat, fi rst move
the centre rear seat belt towards
the middle of the vehicle, so as
to avoid the seat interfering with
the operation of the seat belt.
Your vehicle has been approved in ac-
cordance with the latest ISOFIX regu-
lation .
The seats, represented below, are fi tted
with regulation ISOFIX mountings:
To secure the child seat to the TOP
TETHER:
- remove and stow the head restraint
before installing the child seat on the
seat (refi t it once the child seat has
been removed),
- raise the carpet cover on the TOP
TETHER,
- pass the upper strap of the child seat
behind the seat backrest, between the
apertures for the head restraint rods,
- fi x the hook of the upper strap to the
ring B ,
- tighten the upper strap.
To Next Page
Loading...
