3
COMFORT
75
REAR SEATS
Bench seat with fi xed one-piece cush-
ion and split backrest (left hand 2/3, right
hand 1/3) which can be folded individually
to adapt the load space in the boot.
Rear head restraints
These have one position for use (up)
and a stowed position (down).
They can also be removed.
To remove a head restraint:
release the backrest using control 1 ,
tilt the backrest 2 slightly forwards,
pull the head restraint upwards to
the stop,
then, press the lug A .
Never drive with the head re-
straints removed; they must be
in place and correctly adjusted.
When repositioning the seat
backrest, take care not to trap
the seat belts.
Folding the backrest
Move the corresponding front seat
forward if necessary.
Position the seat belt between the
outer and centre head restraints to
avoid trapping the belt when reposi-
tioning the seat backrest.
Place the head restraints in the low
position.
Pull control 1 forwards to release
the seat back 2 .
Fold the seat back 2 on to the cushion.
Repositioning the seat backrest
Straighten the seat back 2 and se-
cure it.
Check that the red indicator, located
next to the control 1 , is no longer
visible.
Put the seat belt back in place on
the side of the seat backrest.
To Next Page
Loading...
