3
COMFORT
72
Additional adjustments
Head restraint height and angle
To raise a head restraint, pull it up-
wards.
To lower the head restraint, press
the lug A and the head restraint at
the same time.
To adjust the angle of the head re-
straint, tilt its lower part forwards or
rearwards.
The head restraint is fi tted with
a frame with notches which pre-
vents it from lowering; this is a
safety device in case of impact.
The adjustment is correct
when the upper edge of the
head restraint is level with the
top of the head.
With the engine running, the front seats
can be heated separately.
Use the adjustment dial, placed on
the side of each front seat, to switch
on and select the level of heating re-
quired:
0: Off.
1 : Low.
2 : Medium.
3 : High.
Heated seats control
Removing a head restraint
To remove the head restraint, press
the lug A and pull the head restraint
upwards.
To put the head restraint back in
place, engage the head restraint
stems in the openings keeping them
in line with the seat back and press
the lug A at the same time.
Never drive with the head re-
straints removed; they must be
in place and adjusted correctly.
To Next Page
Loading...
