With the key in Drive position
If the radio was on the last time
you switched off the ignition, it
will resume automatically when
you switch on the ignition again.
You will not have to press on
After switching off the ignition,
you can still operate the audio
system even without the igni-
tion key being present. Simply
This radio is coded in such a way
as to function only on your particu-
lar vehicle. It would be unusable if
installed on any other vehicle.
automatic and requires no action
G E N E R A L F U N C T I O N S -
A U D I O A D J U S T M E N T S
To select either Radio, CD (CD
already inserted and Radio source
activated), or CD changer source,
When you insert a CD it automati-
When the radio is switched
off, the source selected is memo-
decrease the sound volume.
You can also increase or decrease
the volume using controls
The sound volume when you
switch off the radio will be the
same when you switch it on
The radio sound volume auto-
matically adjusts to the vehicle
wheel to activate this function.
The sound will be paused, regard-
less of the source selected.
To restore sound, press on con-
at the steering wheel or on
parameter to be adjusted: choice of
predefi ned sound ambiances, bass,
treble, loudness, fade (front/rear
sound distribution), balance (left/
right sound distribution) and volume
adjusted to vehicle speed.
values for the function displayed.
The selection of a sound ambi-
ance automatically adjusts bass
and treble. These can be modi-
To restore the original adjust-
ments for the musical ambiances,
reset bass and treble to zero.
Adjustment of loudness, as well
as bass and treble when they
are available, are specifi c to each
sound source and to each musi-
If you leave the audio system un-
actioned for a few seconds, it will
revert to the normal display.
A superimposition of ambi-
ances, loudness and bass adjustment
may cause vibrations/interference
and result in poor sound quality.