D I E S E L I N J E C T I O N E Q U I P M E N T
In the event of running out of fuel:
HDI 138 and HDi 173 engines
After adding fuel, turn the ignition
seconds, then operate the starter
motor until the engine starts.
If the engine fails to start after sev-
eral attempts, contact a CITROËN
If the engine fails to start after sev-
HDi 110, HDi 138 and HDi 173
engines with priming pump
After fi lling (minimum 5 litres) and
removing the protective cover,
action the manual priming pump,
until some resistance is felt.
Operate the starter motor while
depressing the accelerator pedal
slightly until the engine starts.
If the engine fails to start at the fi rst
attempt, wait 15 seconds before
If the engine fails to start after a
few attempts, action the priming
pump again and then try to start
When the engine is idling, acceler-
ate slightly to complete the bleed-