DS 19 OPERATION No. DS 142-4 : Work on the carburettor controls. Op. DS 142-4 109
PARTICULAR POINTS
Replacement of a control rod.
Removal.
4 Withdraw the rod from underneath the car.
Assembly.
6 Cars produced before March 1956.
In the case of replacement of the outside rod, press down the accelerator slightly in order to obtain an engine speed of between 950 and 1,000
r.p.m.
Do not work on the rod, engine side.
Replacement of a control relay.
Assembly.
9 Adjust the slow running (see Op. DS 142-0).
10 Adjust the clutch re-engagement control (see Op. DS 314-0).
Replacement of an accelerated idling control assembly.
Removal (cars produced before January 1959):
On these cars, it is possible to replace the control assembly, without replacing the feed pipe.
Assembly.
23 Bleed the brake system (see Op. DS 453-0).
24 Adjust the slow running (see Op. DS 142-0).
Replacement of the accelerated idling control joints (cars produced before January 1959) :
27 It is preferable to fit the new type accelerated idling control assembly.
Replacement of the accelerated idling control joints (cars produced since January 1959) :
In order to carry out this operation it is preferable to remove the control assembly (see this operation paragraphs 11 to 16) and then proceed
as for overhauling (see Op. DS 142-6).
To Next Page
Loading...
