PARTICULAR POINTS
Removal.
3 Mark the position of the steering in its bearings and the position of the wheel in relation to the pinion before removing the steering.
7 Do not lose the spacer (4) and the differential bearing adjusting washer (5) (see Pl. 54).
Assembly.
9 If the differential housing is renewed, it is necessary to readjust the new housing (follow the instructions given in paragraph 9).
15 Adjust the position of the brake unit after fitting in position (see Op. DS 451-0).
16 Fit the steering and note the marks made when dismantling.
17 Bleed the front brakes (see Op. DS 453-0).
19 Refill the radiator, vane of the heater control open (bleed).
TOOLS
REMOVAL
1 Hold the bonnet open (stop MR-4158, see Pl. 16, fig. 1). Release the pressure in all the systems. Put the front
of the car on stands (jacking bracket 2505-T, see Pl. 168) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Stop MR-4158
Jacking bracket 2505-T
2 Remove the spare wheel, the spare wheel support, the front wings, the air deflection panel, the battery, the brake
cooling duct and the wheel on the side to be worked upon . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8-12-14 mm box
spanners
3 Remove the steering (see Op. DS 100-1, paragraph 10).
4 Remove the radiator and the brake unit (see Op. DS 451-1).
5 To remove the assembly or the pivot, driveshaft and flexible coupling (bibax) :
a) Remove the screws fixing the sealing plate lining on the sidemember, remove the lining, . . . . . . . . . . . . . . . . . 8 mm box spanner
b) Disconnect the steering rod from the lever on the pivot (extractor 1964-T, and pressure pad 1968-T, see
Pl. 97, fig. 2). Remove the rubber cup and the nylon cup . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Extractor 1964-T
Pressure pad 1968-T
c) Disconnect the front axle arms, from the pivot (extractor and pressure pad 1864-T, see Pl. 97, fig. 3). Remove
the rubber cups and the nylon cups . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Extractor and pressure
pad 1864-T
DS 19 OPERATION No. DS 330 - 4
Replacement of a differential shaft - brake disc or a differential shaft housing
or a front support arm
Op. DS 330- 4 213
To Next Page
Loading...
