DS 19 OPERATION No. DS 314-1 Work on the clutch controls. Op. DS 314-1 174
PARTICULAR POINTS
Replacement of a clutch cylinder.
When assembling, pass the control rod through the belts. Adjust the tension of the belts to 21
1
/2 ft/lb (3 m.kg) (see Op. DS 231-0 and Pl. 35).
Adjust the clutch clearance (see Op. DS 314-0).
Replacement of a clutch cylinder joint.
Dismantling.
17 Wrap the cylinder and piston assembly, in a cloth and blow out the piston with compressed air (circlips removed).
18 Clean the parts with alcohol only.
Assembly.
21 Check the piston cylinder assembly for leakage (see Op. DS 314-3).
Replacement of a clutch engagement control.
30 Clean the parts in alcohol only.
31 Adjust the engagement control (see Op. DS 314-0).
Replacement of a clutch fork.
Removal.
It is necessary to remove the gearbox (see Op. DS 330-1).
Assembly.
42 It is essential to fit a clutch fork spindle fixing screw fitted with a locknut.
46 Adjust the clutch clearance (see Op. DS 314-0).
Replacement of a thrust race.
It is necessary to remove the gearbox in order to carry out this operation.
Replacement of a thrust race nut.
Removal.
It is necessary to remove the gearbox and disconnect the clutch bellhousing from the gearbox casing. Mark the differential bearing distance
pieces and adjusting shims. Disengage the bearing outer cups laterally.
To Next Page
Loading...
