DS 19 OPERATION No. DS 173-3 : Replacement a petrol feed pipe. Op. DS 174-1 122
TOOLS
12 Insert the rear end of the feed pipe in the petrol tank and couple the rear end of the rubber pipe in the union of
the tank. Cut the rear end of the feed pipe obliquely close to the bottom of the tank and fit the drain plug
(insert the joint) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 21 mm box spanner
13 Refit the petrol tank cover plate. Tighten the fixing screws (plain washers under the heads) . . . . . . . . . . . . . . . . 12 mm box spanner
IMPORTANT NOTE - In order to avoid leakage from the rubber connecting pipe to the tank, make sure that
there is a tight joint between the rubber pipe and the tank and between the rubber pipe and the nylon pipe by
using two Ligarex clips, fitted as shown on Pl. 29, fig. 3. Tighten the clips moderately, in order to avoid
deformation of the nylon pipe (pliers 2483-T, see Pl. 17, fig. 2). Pliers 2483-T
Paste the siderail trimming on the petrol tank cover plate (Glutafix T Paste, sold by Establissements Bessier,
125, rue de Reuilly, Paris 12e).
Refit the rear seat and squab . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Pliers 2483-T
14 Engage the front part of the pipe in the opening. on the closing panel.
Put the feed pipe under the clips on the right-hand siderail. Insert the rubber protector. Tighten the strap
fixing screws . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 mm box spanner
15 Fit the finishing panels on the side rail. Tighten the screws (plain washers under the heads).
16 Place the front part of the feed pipe against the closing panels, then behind the front axle arm bracket against the
sidemember and in the front crossmember under the engine. Then insert the pipe through the opening on the
left-hand side of the lower part of the crossmember.
17 Place in position the rubber coupling sleeve to the petrol pump on the front end of the feed pipe. Fit the pipe in
the rubber sleeve using talc to facilitate the work. Connect the sleeve to the petrol pump.
18 Place the feed pipe in the fixing straps on the front closing panel of the sidemember, the front crossmember under
the engine and insert the rubber protectors. Tighten the strap fixing screws . . . . . . . . . . . . . . . . . . . . . . . . . . 8 mm box spanner
19 Fit the side protection panel and the right-hand front wing. Lower the car to the ground (jacking bracket 2505-T,
see Pl. 168).
Fill the petrol tank and prime the petrol pump using the hand control . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Jacking bracket 2505-T
8-12-14 mm box
spanners
To Next Page
Loading...
