DS 19 OPERATION No. DS 175-1 Work on the petrol tank. Op. DS 175-1 128
TOOLS
REPLACEMENT OF A PETROL GAUGE TANK UNIT
Removal.
42 Lift and remove the rear squab. Remove the rear seat.
43 Remove the petrol tank cover plate . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12 mm box spanner
44 Disconnect the negative battery cable, disconnect the leads from the tank unit terminals.
45 Remove the tank unit fixing screws. Remove the tank unit complete with float. Remove the rubber joint between
the tank unit and the petrol gauge.
Refitting.
46 Place the rubber joint for the tank unit on the petrol tank.
Insert the tank unit float into the tank and place the tank unit in position. Tighten the fixing screws (fibre
joints under the heads).
47 Connect the leads to the tank unit terminals. Connect the battery cable (switch on the ignition) and make sure
that the petrol gauge functions.
48 Fit the petrol tank cover plate. Tighten the fixing screws (plain washers under the heads).
Glue the siderail trimming on the cover plate (Glutafix T, sold by Etablissements Beissier, 125, rue de Reuilly,
Paris, 12e) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12 mm box spanner
49 Replace the rear seat and squab.
To Next Page
Loading...
