DS 19 OPERATION No. DS 211-1 Work on the contact breaker. Op. DS 211-1 136
PARTICULAR POINTS
Replacement of a contact breaker (with two breakers).
Removal.
Drain the radiator and remove the inlet manifold (it may be necessary to remove the two upper rear studs).
Refitting.
15 Set the firing point. Do not forget to remove the rod from the flywheel.
23 Refill the radiator, heater control vane open, bleed the system. Check the hot-water circulation.
24 Adjust the slow running (see Op. DS 142-U).
Replacement of a variable ignition control.
Refitting.
Set the firing point (see Op. DS 211-0) after setting the control in the midway position. Do not forget to remove
the rod from the flywheel.
TOOLS
REPLACEMENT OF A CONTACT BREAKER (with two breakers).
Removal.
1 Drain the water from the radiator and cylinder block. (Retain this water which contains anti-freeze).
Hold the bonnet open (stop MR-4158, see Pl. 16, fig. 1) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 21 mm spanner
Stop MR-4158
2 Disconnect the battery negative terminal . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12 mm spanner
3 Remove the tube between the carburettor and air filter-silencer.
4 Disconnect the sparking plug leads.
5 Remove the ignition coils and bracket assembly . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 mm spanner
6 Disconnect the rubber heating pipe from the inlet manifold.
7 Disconnect the petrol feed pipe from the carburettor.
To Next Page
Loading...
