DS 19 OPERATION No. DS 314-1 Work on the clutch controls. Op. DS 314-1 178
TOOLS
REPLACEMENT OF A CLUTCH FORK
Removal (see Pl. 58).
38 Remove the gearbox (see Op. DS 330-1).
39 Unscrew the nuts (2) and (3) and disengage the rod (4) from the fork (see Pl. 45, fig. 1).
40 Remove the clutch thrust retaining spring (73). Remove the thrust race.
41 a) Cars produced before June 1959.
Remove the locknut and the screw (75) retaining the clutch fork spindle (77). Remove the spindle (77), the
spring and the fork . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 mm box spanner
b) Cars produced since June 1959 (see fig. 3).
Remove the two circlips locking the spindle (77) and remove the spindle, the spring and the fork.
Refitting (see Pl. 58).
42 a) Cars produced before June 1959.
Insert the spindle (77) previously oiled in the bore and offer up the fork together with its return spring. Tighten
the screw (75) (plain washer under the head) retaining the spindle (77) and tighten the locknut . . . . . . . . . . . 8 mm box spanner
b) Cars produced since June 1959
Engage the spindle (77), the fork and the spring. Fit the two spindle retaining circlips.
43 Put the thrust race in position, then fix to the fork using the spring (73).
44 Fit the rubber sealing plate on the clutch fork opening.
45 Offer up the gearbox and connect to the engine (see Op. DS 330-1).
46 Adjust the clutch clearance (see Op. DS 314-0).
REPLACEMENT OF A CLUTCH THRUST RACE
Removal (see Pl. 58).
47 Remove the gearbox (see Op. DS 330-1).
48 Remove the clutch thrust retaining spring (73). Remove the thrust race from its hub (76) (see Pl. 52).
Refitting (see Pl. 58).
49 Put the thrust race in position, then fix to the clutch fork using the spring (73).
50 Offer up the gearbox and connect to the engine (see Op. DS 330-1).
To Next Page
Loading...
