DS 19 OPERATION No. DS 330-2 : Preparing the gearbox for stripping down. Op. DS 330-2 194
TOOLS
11 Fit the brake unit and rear support assemblies. Tighten the screws fixing the supports . . . . . . . . . . . . . . . . . . . 14-19 mm box spanners
12 Fit the front brake connecting cable. Fit the sheath stops and connect the cable to the control levers . . . . . . . . . . 12mm box spanner
13 Fit the pulley on the driving shaft. Adjust the position of the pulley (see Op. DS 231-0) . . . . . . . . . . . . . . . . . . . 14 mm box spanner
14 Fit the belts on the driving pulley.
15 Fit the clutch cylinder, connect the control rod to the clutch fork.
16 To fit the high pressure pump.
a) Cars produced since October 1958.
Offer up the assembly of the high pressure pump and connecting pipe between the pump and pressure regulator.
Fit the fixing bolt and offer up the fixing nut (plain and spring washers) (spanner 2280-T, see Pl. 72, fig. 5) . Spanner 2280-T
b) Cars produced before October 1958.
Offer up the high pressure pump and the assembly of the spindle and connecting pipe between the pump and
pressure regulator fitted with new ring seals. Fit the spindle fixing nut (spanner 2280-T, see Pl. 72, fig. 5) . . . . Spanner 2280-T
c) Fix the connecting pipe clamp on the gearbox 14 mm box spanner
d) Fix the tie-rod on the high pressure pump (plain and spring washers under the nuts).
e) Put the belts in position.
17 Fit the dynamo (plain and spring washers under the fixing screws). Put the belts in position. Fit the tie-rod
(plain and spring washers under the nuts).
18 To fit the front crossmember bracket.
a) Offer up the crossmember. Tighten the fixing screws of the crossmember on the gearbox support arms. Turn
over the lockwashers . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14 mm box spanner
b) Fit and tighten the lower nuts of the tie-rod front brackets of the brake units . . . . . . . . . . . . . . . . . . . . . . . . . . 21 mm spanner
21 mm box spanner
To Next Page
Loading...
