DS 19 OPERATION No. DS 334-3 Work on the gear control. Op. DS 334-3 234
PARTICULAR POINTS
To overhaul a gear selector lever assembly.
Assembly.
All the joints and moving parts should be greased (Antar Cardrex EP grease).
19 To adjust the selector gate.
(a) Put the gear lever and the gate in the 4th speed position. Tighten the screw fixing the gate.
(b) Make sure that the gate slides normally on all gears.
(c) Place the lever in the 1st speed position and pin the gate and the control rod.
20 To adjust the tension in the reverse speed position.
(a) Put the selector lever in the - 1st speed position.
(b ) Bring the locking clamp against the tension spring, without clearance or pressure. Tighten the clamp.
(c) Make sure that the lever can occupy the reverse speed position.
To overhaul a gear change speed control.
Dismantling.
23 Do not turn the adjusting screw (55) for the spring (54).
25 Clean the parts with alcohol only.
Assembly.
26 It is imperative to fit a filter (57) even if the gear change speed control was not so fitted (1st model).
To overhaul a hydraulic gear selector.
Dismantling.
Clean the parts in alcohol only.
Assembly.
All the parts should be immersed in hydraulic fluid. Note the markings made when dismantling.
To Next Page
Loading...
