DS 19 OPERATION No. DS 133-1 : Work on the engine mountings. Op. DS 133-1 93
TOOLS
Assembly.
10 Slightly raise the engine-gearbox assembly and offer up the upper crossmember. Place the upper flexible half
collars and caps in position. Insert and tighten the screws securing the crossmember on the support arms,
inserting locking tabs and tuning down on the screws . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14 mm box spanner
11 Lower the engine-gearbox assembly until the crossmember rests on the sidemember. The difference in the
measurements between the brake disc and the sidemember, on the left-hand side should be greater by 70 ± 2 mm
than the same dimension measured on the right-hand side.
Between the sidemembers and the crossmember, insert the number of shims required to give this dimension, the
crossmember must be a good fit between the sidemembers. Tighten the screws securing the crossmember to the
sidemembers (plain and spring washers under the heads of the screw).
Withdraw the chain and remove the stand . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14 mm box spanner
12 Make sure that the rubber blocks are in position on the supports on the crossmember and place the radiator in
position.
Connect the hoses and tighten the clips.
Place he distance piece between the exhaust downpipe bracket and radiator in position and the distance piece
Between the regulator support and the radiator (the longer distance piece is fitted on the exhaust downpipe
bracket side). Insert the fixing screws and centre the radiator; the fan blades must not touch the cowling.
Tighten the radiator fixing screws (plain and spring washers) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14 mm box spanner
13 Fit the radiator tie-bar. Tighten the fixing screw and nut (plain and spring washers) . . . . . . . . . . . . . . . . . . . . . . 12 mm spanner
12 mm box spanner
8 mm box spanner
14 Fit the battery bracket. Tighten the fixing screw (plain and spring washers under the screw heads), insert the
distance piece between the battery bracket and the gearbox support crossmember . . . . . . . . . . . . . . . . . . . . . . 12 mm box spanner
15 Fit the front wings, the spare wheel support and the spare wheel . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12-14 mm spanners
12-14 mm box spanners
16 Fill the radiator. During this operation, open the heater control and bleed the system.
REPLACEMENT OF A FRONT SUPPORT ARM
Removal (see Pl. 54).
17 Remove the differential shaft bearing assembly, the differential shaft, support arm, flexible coupling (bibax)
left side or the differential shaft bearing assembly, the differential shaft and support arm, right side
(see Op. DS 330-4).
To Next Page
Loading...
