CITROEN DS3 - Page 205

203
Practical information
F Startthecompressorbyplacingtheswitch
at the "I"positionandadjustthepressure
tothevalueshownonthevehicle'styre
pressurelabel.
 Todeflate:presstheblackbuttononthe
compressorpipe,atthevalveconnector.
F Oncethecorrectpressureisreached,put
the switch to the "O"position.
F Removethekitthenstowit.
Tyre under-ination
detection
Afterrepairofthetyre,thewarning
lampwillremainonuntilthesystemis
reinitialised.
Formoreinformation,refertothe
"Under-inflationdetection"section.
Shouldthepressureofoneormore
tyresbeadjusted,itisnecessaryto
reinitialisetheunder-inflationdetection
system.
Refertothe"Under-inflationdetection"
section.