CONTENTS
SECTION 1 (continued)
Brakes system - bleeding 1.52
Dissipation (dumping) of hydraulic pressure 1.53
To dump brake system pressure 1.53
To dump a system pressure 1.53
Hydraulic level 1.54
Check 1.54
SECTION 2
ENGINE
Description 2.1
Engine Data 2.1
Removal and installation 2.2
General 2.2
Removal (complete with pod) 2.2
Installation 2.4
Testing 2.4
Removal (pod left on machine) 2.5
Installation 2.7
Testing 2.7
SECTION 3
TRANSMISSION
Description 3.1
Gear selection with APC 3.1
Gear selection without APC (option) 3.1
Technical data 3.2
Gearbox layout (illustration) 3.3
Gearbox type plate (illustration) 3.4
Speed sensor 3.5
Speed sensor rotation 3.6
Sensor test 3.6
Speed sensor to module connection 3.7
Arrangement of solenoids 3.8
Solenoids to module wiring 3.9
APC gear selector module 3.10
Display menus 3.11
Display normal 3.12
Gear selection 3.12
Failure codes 3.14
Display 3.14
Display – Gearbox speed signal 3.15
Display – Machine speed 3.16
Display inputs 3.17
Testing display inputs 3.18
Cable connections from lever to APC 3.19
Pin location from lever (Hobbs) 3.19
APC pin layout 3.20
Testing output from APC 3.21
Kick-down 3.22
Automatic gear change 3.22
Option without APC 3.23
Control lever (Britax) 3.23
Pin layout for control lever 3.24
Control lever to solenoid circuit 3.25
Solenoid switching pairs 3.26
4/3 gearbox 3.26
3/3 gearbox 3.26
To Next Page