USB Operations
English
29 CX501
Connecting a USB memory device
1. Connect the USB memory device to the USB
connector.
Playback will begin from the first file
recorded on the device.
∗ When a USB device is connected, it will switch
to USB mode automatically. If the device is
not recognized, press the [SOURCE] button to
switch the source to the device.
∗ Always insert the device fully into the
connector. Incomplete connections may
cause the device not to be recognized.
∗ Depending on the number of tracks recorded,
some amount of time may be required until all
tracks are read into the unit.
∗ The order in which tracks are recorded may
differ depending on the device connected (the
actual playb ack order may not be the same as
that indicated on your computer’s display).
To listen to tracks on a connected
USB memory device
1. Press the [SOURCE] button to switch the
source. When USB memory device is
selected, playback (except DRM files) will
begin from the location at which playback
was previously stopped.
∗ When a USB memory device is connected,
the USB mode will be displayed.
∗ When a USB memory device is disconnected
and then reconnected, playback will begin
from the beginning of the USB memory
device.
To stop play
1. Press the [SOURCE] button and switch the
function to a source other than the USB
memory.
CAUTION
Do not remove the USB memory device
when the USB mode is selected, since it may
result in loss or damage to data on the USB
memory device.
Always backup and save important data on
your computer.
2. Remove the USB memory device from the
USB cable.
CX501_ENG.book Page 29 Thursday, November 4, 2010 3:55 PM
To Next Page
Loading...
Need help?
General
