Water droplets may form on Let dry for about 1
hour
with the
power
on.
the internal lens when the
car
is parked in a humid
place.
Power
does
not
turn on.
(No sound is
produced.)
No sound output
when operating
the unit with
amplifiers or
power antenna
attached.
Nothing happens
when buttons are
pressed.
80und
is bad
directly after
power
is turned
on.
Incorrect wiring.
Power antenna lead is
shorted to ground or
excessive current is required
for remote-on the amplifiers
or
power antenna.
The
microprocessor has
malfunctioned due to noise,
etc.
DCP or source unit
connectors are dirty.
MP3
files are absent in a
disc.
Files are not recognized
as
an
MP3
file.
File system is not correct.
Compact disc is dirty.
Compact
disc is heavily
scratched
or
warped.
MP3
files are not encoded
properly.
File system is not correct.
The
equalizer levels are too
high.
Replace with a fuse
of
the
same
amperage. If the
fuse blows again, consult
your
store of purchase.
Consult
your
store
of
purchase.
1.
Turn the unit off.
2. Remove all wires attached to the
power
antenna
lead.
Check
each wire for a possible short to
ground using an ohm meter.
3.
Turn the unit back on.
4. Reconnect each amplifier remote wire to the
power
antenna lead one
by
one. If the amplifiers
turn off before all wires are attached, use an
external relay to provide remote-on voltage
(excessive current required).
Turn off the power, then press the
OPEN
button
OJ
and remove the
DCP.
Press the reset button for about 2 seconds with a thin
rod.
~setbutton
Wipe the dirt off with a soft cloth moistened with
cleaning alcohol.
Write
MP3
files onto the disc properly.
Use
MP3
files encoded properly.
Use
1809660
level 1
or
level 2 for file system.
Clean the compact disc with a soft cloth.
Replace with a compact disc with
no
scratches.
Use
MP3
files encoded properly.
Use
1809660
level 1
or
level 2 for file system.
If the equalizer levels are too high, the sound
may
distort. Lower the equalizer levels.
nX7R
1
fiMP
35
To Next Page
Loading...
Need help?
General
