10
FZ104P
AE
1
. This set is exclusively for use in vehicles with a
negative ground 12 V power supply.
2. Read these instructions carefully.
3. Be sure to disconnect the battery “–” terminal
before starting. This is to prevent short circuits
during installation. (Figure 1)
1. Prepare all articles necessary for installing the
source unit before starting.
2.
If you have to do any work on the car body,
such as drilling holes, consult your car dealer
beforehand.
3. Use the enclosed screws for installation. Using
other screws can cause damage. (Figure 2)
1
.
Place the mounting bracket into the instrument
panel, use a screwdriver to bend each
stopper of the mounting bracket inward, then
secure the stopper.
2
. Wire as shown in Section 7).
3. Insert the source unit into the mounting bracket
until it locks.
4. Take care of the top and bottom of the trim ring
and mount it so that all the hooks are locked.
Note:
1. Some car models require special mounting
kits for proper installation. Consult your
Clarion dealer for details.
2. Fasten the front stopper securely to
prevent the source unit from coming loose.
•
Console opening dimensions
1. Do not open the case. There are no user serviceable parts inside. If you drop anything into the unit
during installation, consult your dealer or an authorized
Clarion
service center.
2. Use a soft, dry cloth to clean the case. Never use a rough cloth, thinner, benzine, or alcohol etc.
For tough dirt, apply a little cold or warm water to a soft cloth and wipe off the dirt gently.
INST
ALLATION AND WIRE
CONNECTION
1.
Before Starting
3.
Cautions on Installation
4.
Installation the Source Unit
2.
General Cautions
Batter
y
Figure 1
Max. 6 mm (M5 screw) Figure 2
Chassis Chassis
Damage
7-3/16”
2-1/8”
53 mm
(182 mm)
Hole
English
Owner’
s Manual
To Next Page
Loading...
