4
FZ104P
AE
Note: Be sure to read this chapter ref
erring the
chapter “3. CONTROLS”
CA
UTION
When the unit is turned on,
starting and
stopping the engine with its volume raised
to the maximum level it may cause hearing
damage. Be careful about adjusting the
volume.
Cloc
k Priority Display
Press and hold [ / MUTE ] b
utton on front panel
to power off the unit, the LCD will display the clock.
Note: when the unit is idle f
or more than
10 seconds, the LCD also will display the clock.
Setting
The Clock
1. Press [ MENU ] button to enter System Menu.
2. Press [ ] or [ ] button to select the Clock.
3. Rotate the [VOLUME] knob to set clock, rotating
the [VOLUME] clockwise to adjust the minutes
and counterclockwise to adjust the hours.
P
ower On/Off
Note:
•
Star
t the engine before using this unit.
•
Be careful about using this unit f
or a long time
without running the engine. If you drain the
vehicle battery too far, you may not be able
to start the engine and this can reduce the
service life of the battery.
1. Start the engine. The power button / knob
illumination on the unit will light up.
Engine ON
position
2
. Press the [
/ MUTE ] b
utton to turn the power
On or Off .
Selecting a mode
1
. Press the [SOURCE] button to display source
menu.
* External equipment not connected to this unit
is not displayed.
Adjusting the v
olume
1
. Rotating the [VOLUME] to increase/decrease
the volume.
The adjustable range of volume is 0 to 46.
Adjusting the v
olume
Press
the [MUTE] button to turn the mute On and
Off.
XBS On/Off
Press the [XBS] button on front panel to turn On
or Off the X-BASS booster function.
Displa
y System information
Press the [DISP] button on the front panel to
switch the display information, system time and
playing source.
5.
OPERATIONS
Basic Operation
English
Owner’
s Manual
To Next Page
Loading...
