7
NP509
English
Installing the Navigation Unit
Note:
• Never disassemble the unit by yourself.
1. Attach the Velcro tape.
• Affix the Velcro tape A to the bottom of the unit.
• Attach the Velcro tape B to the vehicle so it is positioned for mating with the Velcro tape A.
Note:
• Peel the backing paper from the adhesive side of the Velcro tape before affixing it to the unit or vehicle.
2. Attach the unit.
• Secure the unit by joining the pieces of Velcro tapes A and B.
Installing the GPS Anttenna
Note:
• The supplied GPS antenna is for installing inside the vehicle. Do not install it outside the vehicle.
• Install the GPS antenna more than 50 cm away from the main unit, other audio devices such as CD player,
and a radar detector. If it is installed near these devices, GPS reception may be impaired.
• It is recommended that the GPS antenna is sited towards the center of the road where GPS signal interruption
is minimized.
• To improve the GPS signal reception, install the GPS antenna horizontally on a flat plane.
• Do not wax or paint the cover of the GPS antenna. This may reduce the performance of the GPS antenna.
• Install the GPS antenna at least 10 cm away from the windshield.
• Wipe off the dirt of the mounting surface before installing the GPS antenna.
Velcro tape A
Backing paper
Velcro tape B
WARNING
• Do not install the GPS antenna in a place where it may interfere with the operation of the
airbag or hinder the driver’s visual range.
• Do not use the navigation system with the GPS antenna cord cut off. The power cables in the
cord may be short-circuited.
To Next Page
Loading...
Need help?
General
