(5)When the following messages were displayed, operate Bluetooth mobile telephone to input a PIN cord.
(6)When pairing completed, registered device name is displayed to screen. And will return Bluetooth setup display.
3-1-2. INCOMING CALL(RECEIVING CALL)
(1)When there was the receipt, the machinery becomes the incoming mode.
To receive a call, perform one of the following procedures listed below.
(a)Highlight [Answer].
(b)Push <PHONE> button on the steering wheel.
3-1-3. OUTGOING CALL(MAKING A CALL)
(1) To making a call, follow the procedures below.
(a)Push <SETTING> , and highlight [PHONE].
(b)Push <PHONE> button on the steering wheel.
(2)THE "PHONE" screen will appear on the display.
(a)Call Phonebook
(a-1)Highlight [Call (Phonebook)] on the "PHONE" menu.
(a-2)Select the registered person's name from the list.
(b)Call logs
(b-1)Highlight [Call (Call logs)] on the "PHONE" menu.
(b-2)Select the name or phone number from the incoming or outgoing call logs.
(c)Dial (Keypad)
(c-1)Highlight [Dial (Keypad)] on the "PHONE" menu.
(c-2)Input the phone number manually using the keypad displayed on the screen.
(3)After the call is over, perform one of the following to finish the call.
(a)Highlight [Hand up].
(b)Push the <PHONE> button on the steering wheel.
3-2. TELEPHONE DIRECTORY TRANSMISSION
(1)PUSH <MENU>, and highlight [Phone].
(2)Highlight [Handset Memory].
(3)When the following messages were displayed. Highlight [YES].
To Next Page
Loading...
