Connecting
the
parking
brake
cord
Connect the cord
to
parking brake lamp ground in the meter panel.
Note:
• Connecting the parking brake
cord
to lamp
ground
allows
you
to watch iPodliPhone
videolDVD videolAV
input
when the parking brake is engaged.
• When the parking brake
cord
is
not
connected, the
monitor
will
not
show
any
video
sources.
•
If''AUDIO
ONLY" appears
on
the screen
just
after
turning on the
ACC
power
of
the car,
release the parking brake while confirming safety,
and
then engage the parking brake
again.
How to attach the electro-tap
1. Place the Parking brake cord at the stopper, and
fold it back in the direction of the arrow.
2.
Pass the Parking brake signal cord through, and
fold it back in the direction of the arrow.
Parking brake
signal cord
~
"jIf
Parking brake cord
(Grass-green)
Stopper
Parking brake
signal
cord.
~
y
~
.
Parking brake cord
(Grass-green)
par~=la~~ms~:~
..
+.-:::.c:::o:::rd::to::::ba_tt_erfY;;i;;;;;::1
Connecting
the
accessories
•
Connecting
to
the
external
amplifier
The external amplifiers can be connected
to
the 6 channel RCA output connections.
Ensure that the connectors are not grounded
or
shorted
to
prevent damage
to
the unit.
•
Connecting
to
iPod/iPhone
device
The iPod/iPhone device can be connected
to
dedicated iPod/iPhone connection on the
main unit. For detailed information, refer
to
the instruction sheet or manual for the
iPod/iPhone cable.
Note:
• This unit
may
not
support
all
functions
of
all iPodliPhone devices.
• The
iPodl
iPhone connection will charge
your
iPodliPhone unless the iPodliPhone
battery is completely depleted.
If
the specified
cord
of
the cellular
phone
is
connected
to the phone interrupt
cord
of
the main unit, the
audio
mute
is activated when cellular
phone in use.
•
Connecting
to
Sirius Satellite Radio Receiver
When Sirius Satellite Radio Receiver is
to
be connected, use the dedicated connector.
For detailed information,refer
to
the instruction manual
of
the Sirius Satellite Radio
Receiver.
VX401NZ401 55
To Next Page
Loading...
