English
English
VX401E/VZ401E
49
Installation manual
Installing the Main Unit in TOYOTA Vehicle
Install by using parts attached to the vehicle. (Screws marked are attached to the
vehicle.)
*2 Some panel openings are too small for the
unit depending on the vehicle type and
model. In such a case, trim the upper and
lower sides of the panel frame by about
0.5 to 1.5 mm so the unit can be inserted
smoothly.
*3 If a hook on the installation bracket
interferes with the unit, bend and flatten it
with a nipper or similar tool.
Vehicles other than NISSAN and TOYOTA
In some cases the center panel may require modification. (Trimming, filing, etc.)
• Removing the Main Unit
When the main unit is to be removed, disassemble it in the reverse of the order in
“INSTALLING THE MAIN UNIT”.
8- Hexagonal screws
(M5x8)
Mounting bracket
(1 pair for the left
and right sides)
Center Panel
(*2)
*3
Main Unit
Figure 7
Typical Mounting Brackets
Example 1 Example 2
Affix the screws to the
marks.
Example 3
VX_VZ401E_EN_GE_FR_IT_ES_multibook.indb 49 4.8.2010 22:03:19
To Next Page
Loading...
