To Next PageTo Next PageHow to reset Clarion Car Receiver?
If nothing happens when you press the buttons on your Clarion Car Receiver and the display is inaccurate, the microprocessor may have malfunctioned due to noise. Press the reset button with a thin rod.
What to do if Clarion Car Receiver sound skips?
If the sound from your Clarion Car Receiver skips or is noisy, the CD might be dirty. Try cleaning it with a soft cloth. If that doesn't work, the CD may be heavily scratched or warped, in which case you should replace it.
Why is there no sound from my Clarion Car Receiver with amplifiers?
If there's no sound output from your Clarion Car Receiver when using amplifiers or a power antenna, the power antenna lead might be shorted to ground, or there might be excessive current required for remote-on the amplifiers or power antenna. To resolve this: 1. Turn the unit off. 2. Remove all wires attached to the power antenna lead and check each for shorts to ground using an ohm meter. 3. Turn the unit back on. 4. Reconnect each amplifier remote wire to the power antenna lead one by one. If the amplifiers turn off before all wires are attached, use an external relay to provide remote-on voltage.
Why is the sound quality poor on my Clarion Car Receiver?
Poor sound quality from your Clarion Car Receiver could be due to a dirty playback head. Use a cleaning tape to clean it. Alternatively, if you're listening to a tape recorded with Dolby NR, make sure the B NR button is pressed and B NR is selected.
What to do if CD cannot be loaded into Clarion ADX5655z?
If a CD cannot be loaded into your Clarion Car Receiver, it might be because another CD is already loaded. Eject the current CD before loading a new one.
General| Brand | Clarion |
|---|---|
| Model | ADX5655z |
| Category | Car Receiver |
| Language | English |
Identification and layout of controls on the main car stereo unit.
Detailed list of all buttons and their functions on the unit.
Fundamental operations such as power on/off and volume control.
Tuning, reception, and band selection for radio functions.
Initial preparations and safety checks before beginning installation.
Important warnings and guidelines to follow during the installation process.
Procedure for connecting the CeNET cable for system communication.
