II.
..111111111
111111111
..
,.,1
If an error occurs, one of the following displays is displayed
Take
the measures described below to eliminate the problem
Displayed when the temperature
in
the MD Lower the surrounding temperature and
changer is too high and playback has been wait for a while to cool off MD changer
stopped automatically
A CD is caught inside the
CD
deck and is
not ejected
A CD cannot be played due to scratches,
etc
Tape cannot be played due to defective
tape such as cut tape
Tape is caught and cannot be played
Tape mode cannot be detected
Tape is caught and cannot be ejected
A
CD
inside the CD changer is not loaded
A CD inside the CD changer cannot be
played due to scratches, etc
A CD inside the
CD
changer cannot be
played because it is loaded upside-down
An MD inside the MD changer is not
loaded
An MD inside the MD changer cannot be
played due to scratches, etc
Displayed when a non-recorded MD is
loaded
in
the MD changer
This is a failure of
CD
deck's mechanism
and consult your store of purchase
Replace with a non-scratched, non-warped
disc
Eject the tape then replace it with a new
one
Remove the caught
or
wound tape
This is a failure of tape mechanism and
consult your store of purchase
Eliminate the reason for which the tape is
caught
This is a failure of
CD
changer's mecha-
nism and consult your store of purchase
Replace with a non-scratched, non-warped
disc
Eject the disc then reload it properly
This is a failure of MD changer's mecha-
nism and consult your store of purchase
Replace with a non-scratched, non-warped
disc
Load a pre-recorded MD
in
the MD
changer
If an error display other than the ones described above appears, press the reset button If the problem
persists, turn off the power and consult your store of purchase
24
ADX5655z