• Output Mode Selector Switch: CH 1/2 and CH 3/4 (XN3410 only)
STEREO: Full left and right stereo operation.
CH1Mono / CH2 Mono: Single channel input for bridged operation. This is
especially useful in high-powered systems. (Uses CH2 and CH4 inputs.)
CH1/2 Mono / CH3/4 Mono: Allows for a stereo input to be summed into a mono
output.
• CH1/2 FREQ / CH3/4 FREQ (XN3410 only) The CH1/2 crossover frequencies
are adjustable from 55Hz to 550Hz. While CH3/4 crossover frequencies are
adjustable from 55Hz to 5500Hz (via the Frequency Range Multiplier) for a wider
range of crossover points. Use this feature along with your speaker
manufacturer's recommended crossover frequencies to quickly design a more
advanced system.
NOTE: If either of the Crossover Mode Switches is set to OFF, varying the
frequency control will have no effect.
• CH1/2 Filter / CH3/4 Filter (XN3410 only) A filter is activated by sliding the
CH1/2 and CH3/4 filter switch to either HP = High Pass or LP = Low Pass.
CH1/2 is fully adjustable from 55-550Hz (via CH1/2 Freq) and CH3/4 is fully
adjustable from 55-5500Hz (via CH3/4 Frequency and Frequency Range
Multiplier). Use this feature along with your speaker manufacture's recommended
crossover frequencies to design a more advanced system.
CONNECTIONS FOR POWER AND SPEAKERS
The rear panel of the XN3410 and XN3210 contains power and speaker
connections as shown below.
Fig. 2
XN3410
To Next Page
Loading...
