Why does my Clarion Amplifier shut off at high volumes?
If your Clarion Amplifier shuts off at high volumes, it might not be getting enough power. Ensure that the voltage at the amplifier does not drop below 10V during operation. Clarion recommends at least 8 AWG power wire for both +12V and GND connections.
What to do if audio stops playing from my Clarion XC1120?
If the audio stops playing, the thermal protection circuit may have shut down the amp to protect the circuitry. Make sure there is adequate ventilation around the amplifier. Also, inspect the fuse at the battery or amplifier and replace it if blown. The amplifier may also be loaded below 2 Ohms per channel (4 Ohms bridged mono on the XC1420); in this case, check the wiring and reconfigure as needed.
How to fix distorted audio from my Clarion Amplifier?
If you are experiencing distorted audio with your Clarion Amplifier, the input gain may not be set properly; adjust it as per the instructions. The source signal may also be distorted, so reduce the source output level. Additionally, the speaker may be damaged and require replacement.
How to stop whining or ticking noise in Clarion XC1120 Amplifier?
If your Clarion Amplifier is producing a whining or ticking noise, check for solid ground connections at the source unit and amplifier, as the amplifier may be picking up electrical noise traveling on the ground shield of the interconnect. You can also run a ground wire from the amplifier to the source unit. Try re-routing the interconnect cables away from sources of electrical noise and ensure you are using good quality shielded interconnects. Also, reroute the speaker wire or passive crossover network wiring, as they may be picking up electrical noise.
How to troubleshoot Clarion Amplifier that will not turn on?
If your Clarion Amplifier will not turn on and the power LED is off or red, use a digital multi-meter to check for 12V at the +12V and REM Connection relative to the ground connection. Also, inspect the fuse at the battery or amplifier and replace it if blown.
What to do if Clarion XC1120 Amplifier fuse blows?
If the fuse blows in your Clarion Amplifier, the amplifier output may be shorted; check all wiring. The amplifier may also be damaged. Remove all speaker wires and check functionality. If the fuse blows with no speakers connected, send the amplifier to Clarion for repair.
Why is there less bass than expected from my Clarion XC1120?
If you're experiencing less bass than expected from your Clarion Amplifier, one speaker or subwoofer may be wired in reverse polarity; switch the + and - leads. Also, the crossover may be set too low; adjust it to a higher frequency.
To Next Page
General
