4-8 GEX/GTX Operator Compartment
Seat Belt: At start up this symbol displays along with an
audio alarm for 4 seconds. This
display reminds you to
fasten your seat belt.
Parking Brake: The symbol is displayed and "-01" status
code appears on the numeric display when parking brake is
ap
plied. Release parking brake to operate truck.
Planned Maintenance:
This symbol is displayed and "-99"
status code appears on the numeric display when the key
sw
itch is turned "ON" and trucks operating hours exceed pre-
programmed hours for planned maintenance. The symbol is
a reminder only and will turn "OFF" after 4 seconds and
display will return to normal operation. The truck shall be
inoperative while this symbol is displayed.
Call Service.
Hour Meter (TMX): This symbol identifies the number
displayed on numeric display as truck and/or pump motor
(o
ptional) operating hours. The symbol is displayed for 2
seconds to 6 seconds when the key switch is turned "OFF".
(ECX): This
indicating lamp shows that the Operating hours
are being counted. It blinks once each second.
Service Status: "-001”, “-066", "-079”, “-217”, “-245” and “-
255” are usually operator fault codes, and can be corrected
by as
explained in "Section 5, Operating Procedures." If you
see any other codes displayed, the truck needs to be
serviced.
Battery Status: If this symbol displays, the numeric display
shows the percentage of usable charge remaining on the
ba
ttery.
To Next Page
Loading...
