Clarke CE7 PRO User Manual

Part No. LT068600 3/14
CE7 Pro, SE7 Pro,
CE7 Pro+ & SE7 Pro+
Edgers
Operator's Manual
Manual del operador
Manuel de l’utilisateur
ACTIVE MODELS: 07170A, 07176A
OBSOLETE MODELS: 07180A, 07175A
This book has important information for the use and safe operation of this machine. Failure to read
this book prior to operating or attempting any service or maintenance procedure to your Clarke
American Sanders machine could result in injury to you or to other personnel; damage to the
machine or to other property could occur as well. You must have training in the operation of this
machine before using it. If your operator(s) cannot read this manual, have it explained fully before
attempting to operate this machine.
All directions given in this book are as seen from the operator’s position at the rear of the ma-
chine.
English (2 - 12)
Español (14 - 24)
Français (26 - 36)
ES
EN
FR
READ THIS BOOK
LEA ESTE MANUAL
LISEZ CE MANUEL

Clarke CE7 PRO Specifications

General

Type	Angle Grinder
Power Source	Corded Electric
Voltage	230 V
No Load Speed	11000 rpm
Spindle Thread	M14

Summary

Operator Safety Instructions

General Power Tool Safety Warnings

Read all safety warnings and instructions to prevent electric shock, fire, and serious injury.

Work Area Safety

Guidance on maintaining a clean and safe work environment to prevent accidents.

Electrical Safety

Instructions for safe electrical connections and handling of power tools to avoid shock.

Personal Safety

Guidelines for operator alertness, protective equipment, and proper body positioning.

Power Tool Use and Care

Guidelines for the proper use, maintenance, and safe operation of power tools.

Service

Instructions for servicing power tools by qualified personnel with identical replacement parts.

Safety Warnings for Sanding Operations

Specific safety precautions and warnings related to sanding operations with the tool.

Kickback and Related Warnings

Information on kickback, its causes, and how to avoid it during operation.

Additional Rules for Safe Operation

Further safety guidelines for dust collection, avoiding sparks, and proper tool assembly.

Introduction and Machine Specifications

Machine Set-Up

Operating Handle

Instructions for adjusting the operating handle for comfort and control.

Abrasive Driver

Details on selecting and installing abrasive discs and drivers for sanding.

Dust Management

Preparing the machine for remote vacuum or included dust bag collection systems.

Electrical Connection

Guidance on connecting the machine to a suitable power source, including safety warnings.

Controls

Explanation of the machine's controls, including the master switch and speed control.

Sanding Pattern

Instructions on how to adjust the sanding pattern for different finishing results.

How to Operate the Machine

Operating Instructions

Step-by-step guide for installing abrasive discs, connecting systems, and starting sanding.

Maintenance

Drive Belt

Recommendations for replacing the drive belt and motor bearings at specified intervals.

Motor Bearings

Guidance on replacing motor bearings at drive belt change intervals and separately.

Abrasive Driver Bearings

Information regarding the lifespan and replacement of abrasive driver bearings.

Carbon Brushes

Instructions for replacing carbon brushes based on usage hours and wear indicators.

Parts Manual

Assembly Drawing

Detailed exploded view diagram of the machine's assembly.

Assembly Drawing Parts List

List of components and their reference numbers corresponding to the assembly drawing.

Handle Assembly

Handle Assembly Parts List

List of parts specific to the handle assembly with reference numbers.

Motor Housing Assembly

Wiring Diagram

Limited Warranty