- 7 -
Using your Generator
(a)
IMPORTANT ! Ensure the generator is not connected to any electrical equipment
when starting the engine.
ON OFF RES
Turn the Fuel ON as shown in fig (4).
Note : The Fuel Tap has three positions : ON, OFF,
and RES (reserve). If the fuel runs low the tap can
be switched to ‘Reserve’ to allow a short period of
further operation. When the fuel gets this low
it is recommended that you refuel (see page 6).
1.
Set the choke by moving the throttle lever in
the direction of the arrow shown in fig (5).
Note : The choke position is indicated by the “ “
symbol .
Fig (5)
2.
Pull the Recoil Starter as shown in fig (6).
Note : To start the engine, pull the recoil Starter
slowly until you feel full resistance, then pull briskly
to turn the engine over. (The engine should start
after no more than three or four pulls. If the engine
does not start see Troubleshooting)
4.
Switch the Ignition ON by pushing the rocker
switch, shown in fig. 5, so that the “I” is
depressed. To turn the engine OFF, push the
switch so that the “O” is depressed.
3.
Return Throttle lever to “ 0 “
as shown in fig (5).
Note : When the engine has started the throttle
should be returned to position “ 0 “ to allow the
engine to run at its set operating level.
5.
Choke
Throttle
“ 0 “
Starting the Engine
Fig (4)
Fig (6)
To Next Page
Loading...
