10
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
USING YOUR GENERATOR
Make sure there is sufficient fuel in the tank before using the generator.
STARTING THE ENGINE
1. Remove all connections from the AC sockets.
2. Turn fuel valve to the ON position.
3. Set the choke lever to the “I”
position (all the way to the left).
4. Set the engine switch to the “I”
(ON) position.
5. Hold the generator handle firmly
and pull the starting handle lightly
until you start to feel resistance
and then pull up sharply to start
the engine.
NOTE: You may have to do this
more than once.
WARNING: ONCE THE GENERATOR HAS STARTED, RELEASE THE STARTING
HANDLE SLOWLY TO AVOID INJURY/DAMAGE AS IT WHIPS BACK.
To Next Page
Loading...
Need help?
General
